Jul 21, 2022 · I am new to routing. In packet tracer, I add a 2911 router, and this router should connect with four networks, but I have only three gig ports for routing. How can I add a new routing interface to 2911, or should I replace it with another model. Thank,

the issue is that my MPLS network (PE router) is connected with I-Direct Sattlite router which is only supporting RIPv2. the client router is not directly connected with our PE router but is connected with I-Directr router. the clients requirements are that …

The IP address 6.45.31.42 is in the interface f0/0 of your router . If your want to block the access from the server to the IP address of the interface f0/0 of your router, then, you must configure: R1(config) #access-list 100 deny ip host 172.16.0.1 host 6.45.31.42. R1(config) #access-list 100 permit ip any any. R1(config) #int f1/0

I am using Packet Tracer for an initial lab. I am not understanding which router I am supposed to choose for the topology. I am trying to get a decice which has a Serial0/0/0 and canot find it. One of the routers has a Serial0/0 and the other a Serial0/0/0. Nothing I choose haas that cofiguration and it is making me pull what's left of my hair out.

So I set up a quick lab, configured NAT on the edge router and tried to ping from company's PC with IP 22.178.50.11 to the 3rd party router behind ISP's AS with IP 22.178.50.1. Well, I've found out that ping is working fine if source and destination IPs are in different subnets (for example, PC with 22.178.50.11/24 and destination with 22.178 ...

vEdge router (WAN Edge) vEdge router - This device, available as either a hardware appliance or software-based router, sits at a physical site or in the cloud and provides secure data plane connectivity among the sites over one or more WAN transports.

Use this command to enable secure copying of files from systems using the Secure Shell (SSH) application. This secure copy function is accomplished by an addition to the copy command in the Cisco IOS software, which takes care of using the secure copy protocol (scp) to copy to and from a router while logged in to the router itself. "

in either case i can ping the server from any router. sample packet tracer file is attached. Expand Post Download file cannot ping when intermediate routes conected though serial.PNG Download

will be included by OSPF when choosing its router ID.) From #2 what is the highest numeric Ip considered : G0/2 is higher than G0/1. Also #3 in IP addresses which direction is considered higher 120.0.0.3 or 192.168.1.1 . Excuse my question but english is not my first language and having problem because in gns3 my router is configured . Router 1

There is no diagram. Just a single router. I was trying to learn the basic things like configuring ip add and stuff. And I selected NM-16ES W module for that. I can do it successfully on NM - 1 FE TX. But I want to know why I am not able to do it on the other one even after using no switchport mode command. Is 16 ES only a switch module?