Plug the RFID module into the breadboard with enough space around it. Connect the VCC pin to the Arduino's 3.3V (not 5V), and GND to the ground rail. For the data connections, wire SDA to Pin 10, SCK ...

LoRa now supports mesh networking thanks to Meshtastic, an open-source platform enabling secure, low-power, long-range ...

EXTENDED FORECAST: Tuesday will be drier with hazy sunshine again.Temperatures will be near normal, in the mid 70s. 80s with a slight chance for showers and thunderstorms return on Wednesday. A ...

Improving performance and integration methods of FCs via maximum power point tracking (MPPT) and high boosting factor ... is proposed in this article for optimizing the design of reduced sensor ...

Abstract: A channel-aware target tracking approach is proposed for multi-hop sensor networks based on M-bit quantized measurements. For two cases where the fusion center has the knowledge of the ...

National and Local Joint Engineering Laboratory for Synthesis, Transformation and Separation of Extreme Environmental Nutrients and MIIT Key Laboratory of Critical Materials Technology for New Energy ...

Sunshine makes a comeback for Wednesday and Thursday, along with warm temperatures in the 80s with rising humidity. Friday brings increasing clouds and cooler temperatures, mostly in the 70s. That is ...

This release is only ment to test things out, this is by no means a full finished module. Worst case scenario the module / app simply doesn't work. Best case scenario - everything mostly just works.

There was an error while loading. Please reload this page.