Plug the RFID module into the breadboard with enough space around it. Connect the VCC pin to the Arduino's 3.3V (not 5V), and GND to the ground rail. For the data connections, wire SDA to Pin 10, SCK ...

Individually addressable LED strip soldered in a 30 x 12 LED grid Arduino Micro SD card reader module Push button 10.000 mAh power bank Wires and copper tape Black cotton fabric Elastic bands Steel wi ...

What could happen when you open-source a hardware project? No, seriously. I hold a fair few radical opinions – one is that ...

Elecrow hit Kickstarter with an electronics learning lab-in-a-box based around the Raspberry Pi. A 2nd generation crammed the lab into a laptop form factor. The CrowPi 3 "playground for programming, ...

Radenta and Danish Ed-tech company, Shape Robotics, have joined forces with the aim to establish robotics in the country’s ...

To remap your buttons on Switch 2, you'll first need to navigate to your console's Settings from the home screen. Once you're ...

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I ...

LoRa now supports mesh networking thanks to Meshtastic, an open-source platform enabling secure, low-power, long-range ...

Before iOS 18, those posts were held by the flashlight and camera buttons, with no way to change them. In iOS 18, you can finally replace them with other buttons -- or remove them entirely ...

As iPhone designs have changed over the years, so have the buttons and commands, which is why the steps for forcing a restart vary depending on the phone you have. So, here's how to force a ...

This kit is now discontinued. We've upgraded the Adafruit Motor Shield v1 to v2, with stacking-support and higher-current motor drivers, Please check out the v2 shield - its much better! Here is a ...

Download all the source files and open examples/ * / *.ino in arduino IDE. Compile and download and run it on a arduino board. The SGP30 uses a dynamic baseline compensation algorithm and on-chip ...