I developed this project by mixing design, 3D printing, electronics, software, and of course, an Arduino. I used an Arduino UNO rev 3, but it is not difficult to adapt the project to a different model ...

There are some exceptions, but most 3D printers run on either an 8-bit Arduino or some Arduino variant ... There’s a small bit of firmware you program on the microcontroller that speaks a ...

By following the tutorial, you can assemble the robot and program it to perform various ... modular robotic kit to transform the 3D printer into an Arduino robot, jump over to the official Delta ...

Arduino may be known for revolutionizing open source hardware platforms, but this week it enters the 3D printer market with the small and affordable Materia 101.

(The Raspberry Pi does have one pin capable of outputting a PWM signal, and software ... your answer: 3D printing and flying drones are among the two most popular activities for Arduino owners.

Today Arduino and Sharebot have announce a new 3D printer they have created and that will be officially launching during this weeks Maker Faire Rome called the Materia 101 3D printer. The Materia ...

Astonishingly, this printer lists Cura, Repetier-Host, ReplicatorG, and Simplify3D as the compatible software ... and the Arduino was very big at the time. 3D printer controller boards were ...