A: In a conventional wiring arrangement, a length of 2 conductor cable is run from the positive and negative terminals of an amplifier to the corresponding terminals on the rear of a loudspeaker. When ...

When it comes to AVRs, you’ll usually find them grouped into three categories. There’s the entry-level models that are often ...

Most speakers and receivers/amplifiers will have speaker terminals that have a hole in the middle for inserting banana plugs. Some have little plastic covers over the holes that you just have to ...

Limited to 250 pairs in matte orange, Audioengine A2+ Next Gen wireless speakers offer bold color, stellar desktop design, ...

Speaker terminals are typically bridged together with clips that can be removed. Each amp deals only with the frequency range needed to drive the specific driver in the speaker.

Connect the other ends of the two speaker cables to the terminals on the Bluetooth receiver, again observing polarity. Plug the 24-volt DC power adapter into the receiver and turn the receiver on.

These curvaceous and futuristic Micropod speakers from Scandyna look oddly familiar; in some way, the Kevlar drives and tube enclosure tweeter reminded me of the legendary B&W Nautilus 800 series ...

Obtain 40mm-long wood screws, caulk, carpet and spray adhesive. A speaker terminal cup, as well as 12-16-gauge speaker wire, is also needed.

HI there, I have a NAD C 316BEE amplifier and both speaker terminals are working however from the right one I am getting a lot of fuzz. I have opened it up and cant see any obvious damage.

Speaker building is a rewarding mix of woodworking and electronics, ... Connecting the crossover input wires to the speaker terminals with a nutdriver, then mounting the cup.

Besides, the speaker connects those terminals with an equivalent of less than 10 ohms resistance, making it pretty damn tough to build up that much potential difference.