The Arduino connects to the FM radio module over I2C. The existing antenna was connected to the TEA5767 module. The radio module outputs stereo audio, but [Marcus] ...

Headline: “FM Radio From Scratch Using An Arduino” Body: “…the FM receiver in this project wasn’t built from scratch…” It’s almost as though he knows, but doesn’t care.

I recently searched for a digital FM transmitter kit, but most of the ones that I found online were either too expensive or did not have enough. ... 13 comments on “ Build Your Own Digital FM Radio ...

Because some hardware setup is required to build up a functioning radio, an Arduino can be used to supply the voltage and control the radio chip. The 3.3-V power can be taken from the Arduino’s ...

Arduino enthusiasts looking for a new project to keep them busy over the weekend may be interested in a new Arduino FM Radio Project, which uses an ATmega328-based board to communicate with a ...

LILYGO T-Embed SI4732 is an ESP32-S3 development board with an AM/FM radio, a TFT display, a rotary encoder, a built-in ...

The HD Radio standard, at least in the US, is encrypted and proprietary, with apparently some rather strong lawyers behind it. So, unless you feel like reverse engineering a few receivers to ...

Watch the video below to learn more about the new Arduino HamShield directly from its creator who has taken to Kickstarter to raise the required $25,000 needed to take his development board into ...